Ultralight For Sale

Shaft Pusher

Does anybody know where I cant find an electric arm that will push a small piece of wood back and forth?

I'm building a coin pusher machine, and I cant seem to find an electric shaft to move the board back and forth. It doesnt need to be very strong. I dont even know what this piece is called really. Any help will be appreciated. Thanks!

It sounds like you're looking for a small electronic actuator. A linear actuator (One that only needs to move in one dimension, back and forth) seems to be what you'd need in this case. Unfortunately, I have never needed to use one for any projects, so I can't give you a ballpark figure on how much it might cost, but the most useful resource I can give you is here:

http://www.nanotec.com/page_linear__en.html

I'm sure that's more of a starting point than anything, but it should give you an idea of what a linear actuator looks like, and if you're lucky, you might be able to find one at a local hobby or electronics retail outlet.

Good luck, sounds like a fun project! =D

Pusher, The $10.49 Pusher, The

Pusher $19.99 Pusher - Poster

Krups Pusher $4.99 Pusher

Kimber Sight Pusher Kimber Sight Pusher $62.99 Heavy-duty steel sight pusher installs onto the screw shaft of your Type II Universal Sight Installation Tool to help you remove install and adjust Kimber sights. Precision-machined engagement lugs correspond with the Kimber sight dovetail to push the sight where you want it to go. Mfg: Kimber SPECS: Steel black oxide matte finish. Approximately 1-23⁄64" (3.4cm) long 1-21⁄64" (3.3cm) high 15⁄16" (24mm) wide.

Pusher - The Trilogy $8.99 Pusher - The Trilogy

Tennessee Pusher $11.49 Tennessee Pusher

Cuisinart Pusher $3 Pusher for LPP and DFP-3

Pedestrian-Pusher $39.99 Pedestrian-Pusher - Giclee Print

Pusher Plane $24.99 Pusher Plane - Photographic Print

Cuisinart Pusher for HFP-300/300BK $5 Pusher for HFP-300

Shaft $6.49 Shaft

Krups Kit/Cover + Pusher $12.99 Kit/Cover + Pusher

Cuisinart Standard Pusher $6 Standard Pusher for DLC-5

Cuisinart Small Pusher $7.5 Small Pusher for DLC-XP

---

Converting your Turnigy Motor to a Pusher Mount



How do you change the water pump impeller on a Mariner 8 hp outboard motor?

I have separated the Mariner 8 hp lower unit from the upper unit , taken apart the water pump, replaced the impeller and pusher the lower unit up on to the upper unit. It guides on fine until the last inch. It feels like the drive shaft is not alligning with the engine drive acceptor socket. The shift linkage appears and feels to be in place. The exhaust down tube feels like it is lined up. I tried turning the prop to rotate the drive shaft but it wont go together that last inch. Can some one help ????

you may have to put the lower unit in fwd gear so as you are pushing up you can move the prop and the drive shaft at the same time to aid in aligning the splines.

Tags: shaft pusher

Comments are closed.