Radio Wiring Solder

Author: admin  |  Category: Ultralight Helicopters

No items matching your keywords were found.


No items matching your keywords were found.

Radio Wiring Solder
Radio Wiring Solder
2000 Chevrolet S-10 radio problems?


I recently took out my aftermarket stereo and reinstalled the factory radio. The aftermarket cd player's faceplate was about ready to fall off. The person who helped me put it in last time didn't secure it well, so it would slide down into the console every time I drove over a good bump. My father-in-law and I had to wire the factory connector back in to the wiring harness. I'm pretty sure it's wired correctly, but now the radio is acting funny. It will only turn on when the engine is running (not even in accessory half the time), and even when it works, it will turn on and off rapidly and randomly. Before I put money into a new cd player, what could it be? Obviously, the constant +12v wire is connected correctly, and all of the speaker wires are connected correctly, because they all work.

One more thing: I soldered and put heat shrink tubing over each connection, so they should be secure.

it sounds like you have a short somewhere.



No items matching your keywords were found.


No items matching your keywords were found.


No items matching your keywords were found.


No items matching your keywords were found.


Metra OP1380 Qwester/Phase Linear Radio Wiring Harness


Metra OP1380 Qwester/Phase Linear Radio Wiring Harness


$10.97


Make your radio installation quick and easy with this Metra radio wiring harness. It has a plug on one end that inserts into the back of the radio, and a universal plug on the other end that connects to the Metra vehicle wiring harness. There are no bare wires to join and solder just plug it in and youre ready to go. The wiring harness has all the necessary power and speaker wires built in, and the high grade ABS plastic plugs provide a perfect connection. A vehicle specific harness is required to connect the vehicles wiring harness to the radio.

METRA 70-7552 Wiring Kit


METRA 70-7552 Wiring Kit


$9.99


70-7552 70-7552 Wiring Kit Plugs into car harness at radio Radio for Nissan 07-up METRA Metra Electronics Wiring Kit www.metraonline.com

METRA 70-8590 Wiring Kit


METRA 70-8590 Wiring Kit


$10.99


1 Year 70-8590 70-8590 Wiring Kit Plugs into Car Harness at radio Power 4 Speaker Radio for 1990-2002 BMW METRA Metra Electronics Wiring Kit www.metraonline.com

Wiring Handbook for Toy Trains (Paperback)


Wiring Handbook for Toy Trains (Paperback)


$27.7


A thorough guide to a solid understanding of traditional, non-electronic wiring for toy train layouts. Readers will learn how to master the basics of electricity and wiring, hook up transformers and other components, connect and solder wire, maintain and troubleshoot a layout, and more.

METRA 70-7551 Wiring Kit


METRA 70-7551 Wiring Kit


$13.99


1 Year 70-7551 70-7551 Wiring Kit Radio for Nissan 1995-2005 Radio for Infiniti 2003 - 2005 G35 Radio for Infiniti 2001 - 2003 QX4 Plugs into Car Harness at radio METRA Metra Electronics Wiring Kit www.metraonline.com

METRA 70-5514 Wiring Kit


METRA 70-5514 Wiring Kit


$11.99


1 Year 70-5514 70-5514 Wiring Kit 705514 One 8-pin power plug, one 8-pin speaker plug and an amp jumper harness Plugs into amplifier harness Power Harness Amplifier Integration Plug Amplifier By-Pass Cable Radio for Ford Vehicles METRA Metra Electronics Wiring Kit www.metraonline.com

Metra Wiring Harness for Select Vehicles


Metra Wiring Harness for Select Vehicles


$19.99


This wiring harness features EIA color coded wires for easy installation of your OEM Acura or Honda radio.

Metra Wiring Harness for Most 1988-2005 GM Vehicles


Metra Wiring Harness for Most 1988-2005 GM Vehicles


$19.99


Make installing an aftermarket radio into your car simple with this wiring harness.

Amplified Wiring Harness for Jeep


Amplified Wiring Harness for Jeep


$149.99


2007-12 Jeep JK Wrangler, Rubicon and Unlimited;Retains the use of the OEM Amplified audio system;Designed to allow the user to replace the OEM Radio with an aftermarket unit;12V accessory output;Adjustable input gain;Navigation outputs Amplified Wiring Harness for Jeep

Metra 705520 Radio Wiring Harness for Ford 03Up Power  4 Speaker


Metra 705520 Radio Wiring Harness for Ford 03Up Power 4 Speaker


$21.81


Product Features:. Plugs into car harness. Power/4Speaker. 24pin connector. For select 20032007 Ford Lincoln Mercury vehicles. Allows for the installation of an aftermarket radio using the existing factory wiring and connectors. No cutting of factory wiring needed. 1year Manufacturer s warranty. Connections:. Yellow 12V Constant. Red 12V Accessory. Black Ground. Orange Dash Light Dimmer/Illumination. Green Left Rear Speaker (+). Green with Black Stripe Left Rear Speaker (). White Left Front Speaker (+). White with Black Stripe Left Front Speaker (). Purple Right Rear Speaker (+). Purple with Black Stripe Right Rear Speaker (). Gray Right Front Speaker (+). Gray with Black Stripe Right Front Speaker ().

Metra 705523 2010 Ford Wiring Harness 16Pin


Metra 705523 2010 Ford Wiring Harness 16Pin


$27.35


Plugs Into Harness at Radio/16Pin. Power and Two Speakers. Allows Installation of an Aftermarket Radio. Using the Existing Factory Wiring and Connectors. No Cutting of Factory Wiring is Needed.

Axxess Wiring Interface for Select 2004-2008 GM Vehicles


Axxess Wiring Interface for Select 2004-2008 GM Vehicles


$79.99


This wiring interface makes installation of a radio simple by providing the +12V output necessary to replace an OEM radio with an aftermarket model.

WELLER SM1 SOLDER-MATE SOLDER DISPENSER


WELLER SM1 SOLDER-MATE SOLDER DISPENSER


$26.99


WELLER SM1 SOLDER-MATE SOLDER DISPENSER

METRA GMOS-04 Wiring Kit


METRA GMOS-04 Wiring Kit


$80.99


GM Vehicles Premium and Bose 2000-08 Retains OnStar with adjustable volume output Retains chimes with adjustable level output Retains RAP feature Navigation outputs included USB update interface compatible The GMOS-04 interface is designed to allow the user to replace the OEM radio with an aftermarket unit in amplified GM vehicles and retain full functionality of the OnStar system as well as all safety and warning chimes. The GMOS-04 will also retain the retained accessory power convenience features. This interface has the capability of adjusting chime and OnStar volumes as well. In addition to these features, the GMOS-04 now has the required outputs for the installation of a navigation radio. GMOS-04 GMOS-04 Interface METRA Metra Electronics Wiring Kit www.metraonline.com

METRA GMOS-01 Wiring Kit


METRA GMOS-01 Wiring Kit


$69.99


GM Vehicles Non-amplified audio systems 2000-08 Retains OnStar with adjustable volume output Retains chimes with adjustable level output Retains RAP feature Navigation outputs included USB update interface compatible The GMOS-01 interface is designed to allow the user to replace the OEM radio with an aftermarket unit in non-amplified GM vehicles and retain full functionality of the OnStar system as well as all safety and warning chimes. The GMOS-01 will also retain the retained accessory power convenience features. This interface has the capability of adjusting chime and OnStar volumes as well. In addition to these features, the GMOS-01 now has the required outputs for the installation of a navigation radio. GMOS-01 GMOS-01 Interface METRA Metra Electronics Wiring Kit www.metraonline.com

Mi03b Wiring Harness For 1987 - 2005 Mitsubishi


Mi03b Wiring Harness For 1987 - 2005 Mitsubishi


$14.94


1987 - 2005 Mitsubishi wiring harness For radio or amp replacement High-strength plastic Color-coded wires

Scosche Wiring Harness for 1987 - 2005 Mitsubishi Vehicles


Scosche Wiring Harness for 1987 - 2005 Mitsubishi Vehicles


$19.99


Replace your radio or amplifier in your Mitsubishi vehicle using this wiring harness that features colored wires for easy installation.



Account limit of 2104 requests per hour exceeded.




Atomic Radio Workshop 4



Hook up more than one amp?


Hey guys, on craigslist a guy is selling 2 mono amps. So im prolly just gonna use 2 amps instead of 1. I know that i need a distribution block and for the REM wire just use a wire and solder together, or hook up a wire from the amps REM input to the other amp. Now my question is... i have 1 amp with a set of RCA jacks but what about the other? How does the other hook up to the radio? Thanks
I think my radio had 3 RCA jacks. Can i just use any of them and the amp will work?

If your stereo doesn't have 2 sets of RCA's the easiest way to do it would be to get 2 Y-Adapters. With 1-male to 2-female outs. Then plug in your 2 sets of RCA wires for both amplifiers. If you don't want to go that route you can get a preamp or crossover which both have 1 set of audio inputs and 2-4 sets of outputs. I hope this helps.

Tags: , , , , ,

Comments are closed.